How many steps does a spiral staircase need?

Divide your total floor-to-floor rise by your maximum allowed riser height and round up — a 2.8m rise at a 241mm (9.5in) maximum riser needs 12 steps. Fewer steps means taller risers (up to your code's limit); more steps gives gentler risers but a longer helical run.

What's the difference between handrail length and inner stringer length?

Both approximate the same helical path at a different radius — handrail length uses the outer arc (the wall-side edge of the tread), while inner stringer length uses the inner arc at the central pole. The outer figure is always longer, since it sweeps a wider radius over the same rise.

What building regulations apply to a spiral staircase in Gibraltar?

Gibraltar's Building Regulations largely follow the UK's Approved Document K framework for private stairs, including spiral and helical configurations, though tread and headroom checks are applied at the stair's walk line rather than the outer wall edge — confirm current requirements with the Gibraltar Development and Planning Commission before finalising a design.

Spiral Staircase Calculator (Gibraltar)

Spiral Staircase Calculator — Steps, Tread Angle & Handrail Length

A spiral staircase's treads are wedges, not rectangles, so the numbers that matter differ from a straight flight. This calculator takes your central pole diameter, overall staircase diameter, total rotation (usually 360°), and floor-to-floor rise, then works out how many steps you need, the actual riser height, the angle each tread sweeps, and the tread's arc width at the inner and outer edges — plus a helical handrail length and the minimum headroom you need above each tread.

How to use the spiral staircase calculator

Enter the inside diameter (central pole or void) and outside diameter (full staircase width), plus the total rotation in degrees the stair turns floor-to-floor (360° for one full turn).
Enter your total rise and your maximum riser rise — many codes cap this around 9.5in (241mm) unless your local standard sets a different limit.
Read off the step count, actual riser height, tread angle, and handrail length, then add a waste percentage and price per tread and per metre of handrail for a materials estimate.

The spiral staircase formula, explained

Step count = ceil(total rise / maximum riser rise), rounded up since no single step can exceed the maximum riser height. Actual riser height = total rise / step count, spreading the rounding difference evenly across every step. Tread angle = total rotation / step count, and inner/outer arc = tread angle (in radians) x the inner or outer radius (arc length = radius x angle). Handrail length ≈ √(outer arc² + actual riser height²) x step count, approximating the helical run.

Worked example: 0.1m inside diameter, 1.6m outside diameter, 360° rotation, 2.8m total rise, 241mm (9.5in) maximum riser. Step count = ceil(2800/241) = 12. Actual riser height = 2800/12 ≈ 233mm. Tread angle = 360/12 = 30°. Outer arc (0.8m radius) ≈ 419mm — the usable tread width at the outer wall. Handrail length ≈ √(0.419² + 0.233²) x 12 ≈ 5.75m.

Pro tips

At a typical Gibraltar material cost of around £50 per tread, the 12-step spiral staircase from the worked example above would need roughly £600 in tread stock alone, before the central pole, handrail, waste allowance, or installation labour — get a quote from a local stair fabricator for an installed price.

Headroom is the check people skip — measure clear height from each tread's leading edge (nosing) up to the underside of whatever is above it; a spiral run under a low opening can fail even when every riser and tread number checks out.
Codes generally check tread width at a walk line partway in from the outer edge, not the full outer arc — confirm your local minimum before finalising a fabrication order.